Write your Feed Back
The PL2303 is a low-cost and high-performance USB-to-Serial Bridge Controller. The PL2303 provides a convenient solution for connecting an RS-232 like a full-duplex asynchronous serial device to any Universal Serial Bus (USB) capable host.
The PL2303 highly compatible drivers could simulate the traditional COM port on most operating systems allowing the existing applications based on COM port to easily migrate and be made USB ready.
Specifications
| Operating Voltage (VDC) | 3.3 ~ 5 |
| Crystal Oscillator | 12MHz |
| Length (mm) | 48 |
| Width (mm) | 16.5 |
| Height (mm) | 2.5 |
| Weight (gm) | 8 |
| Shipment Weight | 0.015 kg |
Features:
- Fully Compliant with USB Specification v2.0 (Full-Speed).
- On chip USB 1.1 transceiver, 5V to 3.3V regulator, and 12 MHz crystal oscillator.
- Supports RS-232 like serial interface.
- Programmable baud rate from 75 bps to 6,000,000 bps.
- Configurable 256-byte outbound buffer and 256-byte inbound buffer or 128-byte outbound buffer and 384-byte
- inbound buffer.
- Supports remote wake-up from MODEM input signals
- Two general-purpose I/O (GPIO) pins
- Optional external EEPROM for startup device configurations
- Small footprint 28-pin SSOP IC package
- Pin compatible with PL-2303HXA and PL-2303XA
Package Includes:
- A 1 x PL2303 USB UART Board (type A)
- 1 x 4-pin custom connector jumper wire
